Nail tips Nail adhesive gel Nail clipper Nail file
For example, some nail products recommend working in a well-ventilated area.
Hold up multiple tips to each nail to find the best fit and then lay them out in the order that you will need them.
If you are concerned about the health of your natural nails, apply a layer or two of clear topcoat before you apply the nails.
If the nail does not have an indented area, then just apply the adhesive gel along the curved edge of the nail. This is the edge that will need to overlap the end of your natural nail. Keep in mind that nail adhesive gel bonds quickly and it is quite strong. Make sure that you have the right nail before you press it onto your finger. If you make a mistake, apply some nail polish remover that contains acetone to the edge of the nail tip. [6] X Research source This will help loosen it so that you can remove the nail tip and start over.
Press on the nail for about five seconds to give the adhesive gel a chance to bond. [8] X Research source Repeat this for all of your nails.
Make sure that you cut straight across. This is especially important if you want square tipped nails. If you want almond or stiletto tipped nails, then you can also cut off part of the sides of the nails. Try cutting a little less than you think you will need to cut. Filing your nails will also shorten them slightly, so you may end up with shorter nails than you’d like if you cut too much.
Place your index finger and thumb on either side of a nail and squeeze gently a few times. Repeat this for all of the nail tips.
Square Almond Oval Round Stiletto
For example, you could try doing a French manicure, tie dye nails, or a try 3D design.
